Fix general errors

there is no listening for this webhook cause this error occurs when a webhook is triggered, but it is not currently associated with any active in other words, the system receives a request at the webhook url, but there is no set up to listen for or process that incoming data users typically encounter this error in one of the following situations a webhook was created but never added to a the that previously used the webhook was deleted, disabled, or no longer uses that webhook an external platform (or an http request) is still calling an old webhook url that is no longer in use the webhook was intentionally abandoned, but the external system was not updated to stop sending requests because webhooks can be triggered by many different sources, the exact cause depends on how and where the webhook url is being used solution since this issue is context dependent, the appropriate solution depends on the intended use of the webhook if the webhook is still needed associate the webhook with an existing or create a new that listens for it if the webhook should no longer be used stop triggering it by updating or removing the webhook url from the external platform or request source if the webhook was replaced or changed ensure that the external system is calling the correct, currently active webhook url if the webhook is permanently unused consider deleting it to avoid confusion note that deleting the webhook will cause future requests to return a 410 – webhook not found error, so make sure external calls are removed or updated first module initialization failed with an error cause in rare cases, a webhook may fail to start and display a module initialization failed with an error, showing 0 operations executed although the webhook queue may contain events, none are processed because the never begins execution before a executes, all modules must be initialized during this initialization phase, the platform verifies any connections attached to modules in the following order the webhook module has a connection attached during initialization, the webhook module verifies the attached connection if the connection is broken, expired, or no longer valid, the verification fails as a result, the webhook module fails to initialize, and the entire does not start because the never starts, the webhook cannot process queued events solution depending on the setup, one of the following actions is required reauthenticate the connection if the connection supports reauthorization, reauthenticate it so the webhook module can successfully initialize replace the connection if the connection is legacy or cannot be reauthorized, create a new connection and attach it to the webhook module detach the connection if the webhook does not strictly require the connection for runtime behavior, detaching it will allow the module to initialize and process events